Manley REFERENCE MICROPHONES - 1992 - 2010 Manual de usuario descargar pdf (Pagina 8)

A IEC POWER CONNECTOR: Connector for AC power input.

B FUSE HOLDER: Replace with 1A SLO-BLO fuse only.

C VOLTAGE CHANGEOVER SWITCH: Set for the correct mains voltage for

your area by rotating the centre section with a flat screwdriver.

D MICROPHONE POWER CONNECTOR: Align notch with supplied cable and

carefully insert. Tighten by turning outside barrel clock-wise.

E Power Switch: Pressing the top of this switch turns the supply on.

POWER SUPPLY

SPECIFICATIONS GOLD SERIES

MICROPHONE TYPE: DUAL LARGE DIAPHRAGM CAPACITOR

POLAR PATTERNS: CONTINUOUSLY VARIABLE

DIAPHRAGM SIZE: 1 INCH ; 1.25 INCH OVERALL

DIAPHRAGM THICKNESS: 3 MICRON; GOLD SPUTTERED

FREQUENCY RESPONSE 10 HZ to 30 KHZ, AMPLIFIER to 60 KHZ

MAXIMUM INPUT SPL: 150 dBSPL AT CAPSULE

SENSITIVITY: 19mV/Pa

AMPLIFIER TYPE: 2 TRIODE GAIN BLOCK LO Z OUTPUT

ACTIVE COMPONENTS 1) 12AX7LPS TUBE (2 for STEREO MICS)

OUTPUT TYPE : TRANSFORMER WITH FEEDBACK LOOP

OUTPUT POLARITY: BALANCED XLR, PIN 2 HOT, PIN 3 LOW

AMPLIFIER DISTORTION: LESS THAN .05 %

AMPLIFIER NOISE: TYPICALLY -120 dB EIN (TUBE DEPENDENT)

BODY: 24 KARAT GOLD OVER MACHINED BRASS

GOLD PSU BACK ALL MODELS: FRONT

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Manley REFERENCE MICROPHONES - 1992 - 2010 Manual de usuario Pagina 8